Read these Honeywell VisionPRO TH8000 Manual carefully. Failure to follow these instructions can damage the product or cause a hazardous condition. If this product is replacing a control that contains mercury in a sealed tube, do not place the old control in the trash. Contact your local waste management authority for instructions regarding recycling and proper disposal. Remove factory-installed jumper only for two-transformer systems. Push excess wire back into the wall opening. Plug wall opening with non-flammable insulation. Align pins on back of thermostat with slots in wallplate, then push gently until thermostat snaps into place. Compressor protection is bypassed during testing. To prevent equipment damage, avoid cycling the compressor quickly.
RedLINK Prestige, VisionPRO, and FocusPRO thermostat models can be wirelessly linked to the below RedLINK zone panel kits using a THM4000R1000 Wireless. Individual System Components. Prestige and RedLINK 8000 Thermostats lose the below functionality when linked to a RedLINK zone panel.You cannot control IAQ control. : Honeywell Honeywell-Th8320R-Users-Guide-803616 honeywell-th8320r-users-guide-803616 honeywell pdf Honeywell Th8320R Users Guide 69 2761EFS 03 VisionPRO® Series With RedLINK™ 2015-08-26.
Auto Changeover (Setup Function 0300): When set to Auto, the thermostat automatically selects heating or cooling depending on the indoor temperature. Heat and cool settings must be at least 2 degrees apart. If function 0380 is set to On, the heat and cool settings must be at least 5 degrees apart. Remote Sensor (Setup Function 0340): If an optional outdoor sensor is installed, the thermostat can display the outside temperature. If an optional remote indoor sensor is installed, the thermostat will display the temperature at the sensor location (the internal sensor in the thermostat is not used). Adaptive Intelligent Recovery (Setup Function 0530): Allows the thermostat to “learn” how long the furnace and air conditioner take to reach programmed temperature settings, so the temperature is reached at the scheduled time. Compressor Protection (Setup Function 0580): Forces the compressor to wait a few minutes before restarting, to prevent damage. During this time, the message “Wait” flashes on the display. Dehumidification control (Setup Function 0380): TH8321 models monitor the indoor humidity level and automatically activate the cooling system to reduce humidity by lowering the temperature by up to 3 degrees below the current cool setting.
Heat Pump Temperature Lockout (with fossil-fuel backup): If the thermostat is installed with an optional outdoor sensor, you can select a compressor lockout temperature (Function 0350). When the outdoor temperature is below the lockout temperature, only the auxiliary heat operates. When the outdoor temperature is above the lockout temperature, only the compressor operates. Heat Pump Temperature Lockouts (with electric heat backup): If the thermostat is installed with an optional outdoor sensor, you can select a compressor lockout temperature (Function 0350) and/or an auxiliary heat lockout temperature (Function 0360). When the outdoor temperature is below the compressor lockout temperature, only the auxiliary heat operates. When the outdoor temperature is above the auxiliary lockout temperature, only the compressor operates. If the outdoor temperature is between the compressor and auxiliary lockout temperatures, both the compressor and auxiliary heat can operate.
Redlink Visionpro 8000 Installers Manual
Download or view Honeywell VisionPRO TH8000 Manual below