- Kenwood Ddx418 Wiring Manual Download Online
- Kenwood Ddx418 Wiring Manual Download Windows 10
- Kenwood Ddx418 Wiring
How to read this manual:. Illustrations of DDX4048BT are mainly used for explanation. This manual mainly explains operations using the buttons on the monitor panel and touch panel. For operations using the emotr e controller (RC-DV340: supplied only for DDX4048BT/DDX3048 ), ☞ page 48. indicates the variable screens/.
56
DDX418/DDX4048BT/DDX318/DDX3048
What appears to be trouble is not always serious. Check the following points before calling a
service center.
• For operations with the external components, refer also to the instructions supplied with
the adapters used for the connections (as well as the instructions supplied with the external
components).
If the following messages appear
Message
Remedy/Cause
“No Signal”
• Start the playback on the external component connected to AV-IN
input terminal.
• Check the cords and connections.
• Signal input is too weak.
• “Miswiring DC
Offset Error”
• “Warning DC Offset
Error”
A speaker cord has shorted or it has come in to contact with the car
chassis. Wire or insulate the speaker cord as appropriate, then reset
the unit (☞ page 3). See also the INSTALLATION MANUAL.
“Parking off”
No playback picture is shown when the parking brake is not
engaged.
“Authorization Error”
Check whether the connected iPod/iPhone is compatible with this
unit. (☞ page 20)
“USB Device Error”
• The USB power voltage is abnormal.
• Turn off and turn on the unit.
• Connect another USB device.
“No BT Dongle”
Bluetooth adapter (KS-UBT1) is removed.
“Connection Error”
The device is registered but the connection has failed. Connect the
registered device. ( ☞ page 41)
“Please Wait...”
The unit is preparing to use the Bluetooth function. If the message
does not disappear, turn off and turn on the unit, then connect the
device again (or reset the unit).
“NO Voice Device”
The connected mobile phone does not have the voice recognition
system.
“NO Data”
No phone book data is contained in the connected Bluetooth phone.
“Initialize Error”
The unit has failed to initialize the Bluetooth module. Try the
operation again.
“Dial Error”
Dialing has failed. Try the operation again.
“Hung Up Error”
The call has not ended yet. Park your car, and use the connected
mobile phone to end the call.
“Pick Up Error”
The unit has failed to receive a call.
“Pairing Mode Error”
Pairing between the unit and Bluetooth device has failed. Register
the device again. (☞ page 40)
Kenwood Ddx418 Wiring Manual Download Online
Troubleshooting
EN_DDX_K.indb 56
Kenwood Ddx418 Wiring Manual Download Windows 10
EN_DDX_K.indb 56
10/12/20 18:36
Kenwood Ddx418 Wiring
10/12/20 18:36